This is an old revision of the document!

pNav2 - Pico Satellite GPS Receiver

Features

GPS L1 C/A navigation receiver for CubeSats
Low size and weight compatible with 1U CubeSat
Low power consumption
Radiation-tolerant design → long live in LEO
15 channels
DSP acquisition unit for satellite acquiring acceleration
Deduced reckoning when losing the GPS satellites
Customizable output protocol
- Extended NMEA protocol
- Easy to process binary protocol
- Earth-Centered Earth-Fixed position and velocity vectors
Easy to integrate antenna kit
Development kit
Evaluation software
Engineering model and Flight model licences
Configurable NMEA and Binary messages
Flight heritage

pAnt - GPS L1 Antenna Kit

Easy to integrate GPS L1 Antenna
- Patch antenna
- Antenna Cap
- LAN
- Test panel
Small dimensions
Low power consumption
Now special knowledge for integration

pNav2 Design Requirements

====== pNav Design Requirements ======
* The CubeSat navigation receiver should be as simple as possible and integrate all necessary parts for navigation in the LEO Orbit.
* It should be compatible with a 1U CubeSat platform, ie, power consumption should be a fraction of the power budget of 1U satellite. The receiver should be small and light.   
* The applied signal and measurement processing algorithms should be simple and very robust

+

Short Cold Start
Continuous positioning of a rotating (unstabilized) 1U CubeSat

Table of Contents

pNav2 - Pico Satellite GPS Receiver

Features

pAnt - GPS L1 Antenna Kit

pNav2 Design Requirements

+